Build the MassCalculator Docker

The MassCalculator Docker is built using CMake, therefore two steps are needed:

CMake Configuration

Create a build directory, anywhere but inside the source directory. Call CMake using the following commands:

Basic Configuration, Debug, no Extra Tools, no Tests, no Documentation

cmake -S $MASSCALCULATOR_DOCKER_SOURCE -B <BUILD DIRECTORY> -t <TARGET> -G Ninja -DCMAKE_BUILD_TYPE=<Debug|Release>

Configure Build with Doxygen Documentation

cmake -S $MASSCALCULATOR_DOCKER_SOURCE -B <BUILD DIRECTORY> -t <TARGET> -G Ninja -DBUILD_DOCS=ON -DCMAKE_BUILD_TYPE=<Debug|Release>

Build

From the build directory call

Build targets

sudo cmake --build <BUILD DIRECTORY> -t <Target> --config <Debug|Release>

Note: Sudo is needed to give permission to docker for Dockerfile build.

Available targets

• build-conan-masscalculator-core-docker
• run-conan-masscalculator-core-docker
• build-masscalculator-core-docker
• run-masscalculator-core-docker

Documentation

The Doxygen documentation will be available under the subdirectory docs/html of your build directory. E.g., in build/docs/html.