The MassCalculator GUI is built using CMake, therefore two steps are needed:
CMake Configuration
Create a build directory, anywhere but inside the source directory. Call CMake using the following commands:
Basic Configuration, Debug, no Extra Tools, no Tests, no Documentation
cmake -S $MASSCALCULATOR_GUI_SOURCE -B <BUILD DIRECTORY> -G Ninja -DCMAKE_BUILD_TYPE=<Debug|Release>
Configure Build with Doxygen Documentation
cmake -S $MASSCALCULATOR_GUI_SOURCE -B <BUILD DIRECTORY> -G Ninja -DBUILD_DOCS=ON -DCMAKE_BUILD_TYPE=<Debug|Release>
Build
From the build directory call
Build everything
cmake --build <BUILD DIRECTORY> --config <Debug|Release>
Documentation
The Doxygen documentation will be available under the subdirectory docs/html of your build directory. E.g., in build/docs/html.
